I had some bags of 5″ and 6″ propellers around that lacked nose pieces.
They were purchased a while back when I just started making Squirrel kits and I was assessing different propellers.
Also a batch was purchased at one point when I was low on propellers and needed some in an emergency. It was a pain since I had to buy nose pieces and other hardware.
What was left over of these have been sitting in my “research bin” for quite some time.
I am testing the new 3D printer by making nose pieces so I figure this is a great chance to put these props into use!
I got some .030″ music wire some small beads and presto! Complete propellers with nose piece assembly!
The propellers I have use .0375″ wire which is a little thicker. I will come up with the best size over time.
I will bring them to my next volunteer activity and we can test out the hubs to see if there are any problems with them. I made up about 10. I can already see that the down thrust didn’t come to the angle I intended. I’m not sure if this is a problem yet so we’ll find out next building session!
Do u know any propeller shop in nepal ?
No sorry. Send me a note at darcy@siteware.com with your address. Feel free to send any pictures of what you have so far as well.
Do you sent propellers to Kiran?
If I get an email I may.
Can you send me a propeller with nose piece… plz
Can you send me a propeller with nose piece… plz
you have so many..:P