Be sure the glue is dry before attempting this step.

Put the small elastic band (about an inch diameter) on the Motor Stick. Slide the back of the Wing underneath it. While holding the Wing in place on the Motor Stick, stretch the elastic over the top of the Wing and loop it onto the Motor Stick from the front.

You can slide the Wing forward and backward to make adjustments for trimming.

You can remove the Wing and store your airplane in a shoebox.

If you prefer to stretch the elastic underneath, be sure to twist it 90 degrees before looping on the front.

Tip: Put the lids on the glue containers.

Step 17: Attach Propeller

It should fit snugly onto the front of the motor stick. Be sure to hold the Motor Stick very close to the front when attaching the Propeller.

Tip: If the fit is too loose, glue a piece of a toothpick to the top and/or bottom of the motor stick. This is also helpful if your motor stick is made from very soft wood. If the fit is too tight, scrape some wood away from the top or bottom of the Motorstick with a scissor blade.

Continue to Next Steps >>>>